Harbor Freight Tools 65204 - Manual (Page 12)

Page 12 For technical questions, please call 1-800-444-3353. SKU 65204/
99918
user-maiNteNaNce
iNstructiONs
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
tO PreVeNt
seriOus iNjurY
FrOm accideNtal
OPeratiON:
disconnect spark plug and
release all air pressure before
maintenance.
tO PreVeNt seriOus
iNjurY FrOm tOOl
Failure:
do not use damaged
equipment. if abnormal noise,
vibration, or leaking air
occurs, have the problem
corrected before further use.
tO PreVeNt seriOus
iNjurY:
do not adjust or tamper with
any control or component in a
way not specifically explained
within this manual. improper
adjustment can result in tool
failure or other serious
hazards.
cleaning, maintenance, and
lubrication
Note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular op-
eration of the air-operated tool.
daily
Check compressor oil level at sight 1.
glass. Add premium quality SAE
30-weight, non-detergent, synthetic
air compressor oil as needed. Do not
mix oils of different types.
Check engine oil level. Add oil as
2.
needed according to engine manual’s
instructions.
Drain moisture from tank.
3.
Weekly
Inspect air pump’s Air Filter (67). Re- 1.
place if necessary. To replace:
Unscrew the wing nut holding the a.
filter cover.
Remove the filter cover.
b.
Remove the filter element and re- c.
place with a new one.
Slide the filter cover back over the
d.
filter element and screw the wing nut
back on and tighten securely.
Check safety valve by pulling and re- 2.
leasing ring. Valve should seal once
released.
Clean excessive dirt/dust from unit.
3.
monthly
Check and adjust belt tension accord-
ing to the steps below:
Remove the belt cover and set it
1.
aside.