Homelite UT08512B - Manual (Page 12)

12 13
MAINTENANCE
WARNING:
When servicing, use only identical Homelite replacement
parts. Use of any other parts may create a hazard or
cause product damage.
WARNING:
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrication
is required.
Fig. 8
REPLACING AND CLEANING THE AIR FILTER
See Figure 8.
For proper performance and long life, keep the air filter
clean.
�n Push down on the latch of the air filter cover; carefully
pull the top of the air filter cover so it pivots away from
the base.
�n Remove the air filter and clean it in warm soapy water.
Rinse and let dry completely.
�n Reinstall the air filter into the air filter base.
�n Pivot the cover back in place. Push the latch back into
the slot and ensure the cover is locked in place.
NOTE: The filter should be replaced annually for best
performance.
AIR FILTER BASE
AIR FILTER
COVER
LATCH