Huffy Portable System - Manual (Page 11)

01/04 P/N 211955E
11
IMPORTANT! Center
alignment slot of lower pole
section (6) in a lower hole of
middle pole section (5) as in
step 3. While maintaining
alignment, bounce top & middle
pole assembly (4 & 5) onto
lower pole section (6) as shown
until top & middle pole assembly
no longer moves toward taped
reference mark on bottom pole.
5
4
4
5
6
WOOD SCRAP
(NOT SUPPLIED)
IMPORTANT! Center alignment slot of
middle pole section (5) in a lower hole
of top pole section (4) as shown. While
maintaining alignment, bounce middle pole
(5) into top pole section (4) as shown until
top pole section no longer moves toward
taped reference mark on middle pole.
Upright assembly.
WOOD SCRAP
(NOT SUPPLIED)
POLE SECTIONS
SHOULD HAVE A
3-1/2" (9 CM)
MINIMUM OVERLAP.
NOTE:
POLE SECTIONS
SHOULD HAVE A
3-1/2" (9 CM)
MINIMUM OVERLAP.
NOTE:
4.
5.