Heath Zenith DualBrite Motion Sensor Light Control 5797 - Manual

© 2007 HeathCo LLC 598-1315-02
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Three lamp modes available: Normal, Soft, or Flash.
• D
ual
B
rite
® Timer.
• Photocell keeps the lighting off during daylight
hours.
• LED indicates motion was sensed (day or night).
Requirements
• The light control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
wired through a switch.
• Some codes require installation by a qualified
electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
2 Wire
Connectors
Gasket
6 Mounting
Screws (3 sizes)
Mounting Bolt
Mounting Strap
Rubber Plug
OPERATION
* resets to Auto Mode at dawn.
TEST
ON-TIME
TEST 1 5 20
AUTO
Note: When first turned on wait about 1 1 /
2
minutes for
the circuitry to calibrate.
Light Shield
Plastic Hanger
This package includes:
Put the ON-TIME switch in the 1, 5,
or 20 minute position.
Mode: On-Time: Works: Day Night
Test 5 Sec x x
Normal 1, 5, 20 min. x
Manual Until Dawn* x
Accent 3, 6 Hr. to Dawn x
LAMP MODE
NORMAL SOFT FLASH
LAMP MODE
Put the LAMP MODE switch
in the Normal, Soft, or Flash
position.
TEST 1 5 20
ON-TIME
Off 3 6 Dusk to
Dawn
D
ual
B
rite
® Put ON-TIME switch
on the sensor bottom
to TEST and the D
ual
-
B
rite ® switch OFF.
Light Control
Sensor
Cover Plate
2 Halogen Bulbs
(Installed)
Model 5797
D
ual
B
rite
® Motion
Sensor Light Control
Meets the ENERGY STAR ® guidelines
when D
ual
B
rite
® function is off and
ON-TIME is 1 or 5 minutes.