HP 2000CP 2500CP - Manual (Page 81)

User Messages 3-13 HP DesignJet CP Series Printers
Message Explanation and Action
Replace ink
cartridge(s)
JJJ- You are in the ink system replacement process, and opened the left door when
instructed.
The printer is waiting for you to replace the ink cartridges indicated by flashing
squares.
Replace lens cover
Continue
→
You are in the ink system replacement process, and lifted the window when
instructed.
The printer is waiting for you to replace the lens cover on the printhead carriage
with a new one. Spare lens covers are inside the right door. Press
↓
to continue
when you have completed the lens replacement.
Replace
printhead(s)
JJ-J You are in the ink system replacement process, and lifted the window when
instructed.
The printer is waiting for you to replace the printheads indicated by flashing
squares.
Replace
printhead(s)
Close window You are in the ink system replacement process, and lifted the window when
instructed.
The printer is waiting for you to replace a printhead, or you can close the
window without making any changes.
Replace
JJJ-
Close right door
You are in the ink system replacement process, and opened the right door when
instructed.
The printer is waiting for you to replace the printhead cleaners indicated by *s,
and then close the right door.
Replacement of ink
system
recommended
→
You are about to finish the ink system replacement process, and the printer
recommends replacing one or more of the four ink systems (for example, because
they have passed their specified life).
Press the
↓
key to continue. You will see the status message
ILow on inkI.
Then
press the Replace Ink System key to replace the ink systems that will be
indicated.
Replacement of lens
cover
recommended
→
The printhead alignment procedure, or the printhead check procedure, or a
calibration check has failed because the lens cover is dirty and needs replacing.
Printing may continue but the image quality is not assured.
Press
↓
to continue. Replace the lens cover. Spare lens covers are inside the right
door.
Resource area full
Unable to save res. (HP DesignJet 2500CP/3500CP only) The printer’s hard disk is full. You are
attempting to save resources. The printer is unable to process the request.
You need to remove some of the resources from the hard disk, for example, saved
print files, halftones, or fonts that you don’t use. Then try saving the resource
again.