Harbor Freight Tools Chicago Electric 4" Table Saw with 2 Blades 93211 - Manual (Page 6)

Page 6 SKU 93211 For technical questions, please call 1-800-444-3353.
Operation
1. Place your Table Saw on a flat, level surface capable of supporting weight of
Table Saw and material being cut before use. Always wear ANSI-approved
safety goggles when operating this tool and ensure that all guards are in place
and in proper working order.
2. Mark your work pieces with a pencil or other writing instrument before you be-
gin cutting. Loosen the Knob (7) on the Straight Edge Guide (8) and turn the
Guide to the appropriate angle for your specific cutting requirements. Tighten
the Knob to hold the Guide in place.
3. Plug in the Power Cord (24).
4. Lift the Eye Guard (5) and slide the Straight Edge Guide out far enough to allow
you to lay your work piece flat on the Table (32). Lower the Eye Guard onto
your work piece. Never remove the Guard (4) or attempt to operate this
tool without the Eye Guard (5) in place.
5. Flip the Power Switch (18) to the On position.
6. Using the Straight Edge Guide to hold your work piece steady, gently feed your
work piece toward the Blade. Keep your fingers and all other body parts
away from the Blade at all times. If your work piece is particularly small, you
may want to use another small piece of wood or other material to push your
work piece toward the Blade. Do not push forcefully against the Blade, or use
materials that are particularly difficult to cut. If the Blade slows down as you
are feeding your work piece toward it, you are pushing too forcefully, or the
material is too hard for this tool to cut.
REV 06c