Heath Zenith Motion Sensing Porch Light SL-4303 - Manual (Page 2)

2 598-1348-00
DU AL BRITE ®
ON -TIM E TE ST 1 5 10 MIN OFF 3 6 D US K
TO DA WN
DU AL BR
ITE ®
ON -TIM E
TE ST 1 5
10 MIN
OFF 3
6 D USK TO DA WN
instaLL universaL mOunting
Bracket
For best performance, mount the fixture at least
8 feet (2.4 m) above the ground.
Fixture Screw (Tightened
Finger Tight)
Junction Box
Universal Mounting
Bracket
Junction Box Screw
wiring Light Fixture
1. Connect the junction box wires and the fixture
wires together as shown in the following dia-
grams.
cautiOn: dO nOt remove wire connec-
tor from red wire or connect the red wire
unless you want to control other lights from
this motion sensor fixture.
disassemBLe Light Fixture
1. Remove three decorative nuts from light fixture
cover.
2. Remove cover from base.
3. Remove two decorative nuts from fixture screws
in universal mounting bracket.
4. Remove universal mounting bracket from
base.
Decorative Nut
Light Fixture Base
Light Fixture
Cover
Decorative Nut
Universal
Mounting
Bracket
Note: If you have a metal junction box use the recom-
mended grounding method shown in the following
illustration. If you are uncertain about the grounding
method, consult your local building code.
2. Twist and secure wires with wire nuts.
D
ual
B
rite
® dimmer cOntrOL
Light comes on half bright for selected time after dusk
(Off, 3 hr., 6 hr., until dawn). Selecting OFF disables this
feature. The motion sensing features will continue to
work as described in this manual. If motion is sensed,
the light turns on full bright for the ON-TIME (1, 5, or
10 minutes) then returns to dim mode.
warning: turn power off at circuit
breaker or fuse.
1. Tighten the two fixture screws finger tight.
2. Attach universal mounting bracket to junction
box securely with the two screws provided.