Husky H1600 User Manual

Page 22

Advertising
background image



PRoBLeM oR conceRn PossiBLe cause

soLution

No water coming out of

Wand

Gun/Hose Assembly is defective Attach the Gun/Hose to the front of the unit with

no wand attached to the Gun.

Squeeze the trigger of the gun to ensure that water

comes out of the front of the Gun at a rate equal

to the Garden Hose. If no water comes out of the

Gun, remove the gun and the hose to ensure that

water flows out of the pump. If it does, the gun will

need to be replaced. Contact us at:

[email protected]

or order a replacement directly online at:

www.huskypowerwasher.com.

Trigger will not move

Gun Safety Lock in engaged

Release Safety Lock as instructed in Manual.

Unit will not start

Note: Unit will only start when
trigger is depressed.

Unit stops while operating

Unit is not turned on

Press ON/OFF Switch into ON position.

Loose or disconnected Plug

Reconnect Plug.

Defective GFCI Plug

If the GFCI does not work it will need to be re-

placed. Contact us at:

[email protected]

or order a replacement directly online at:

www.huskypowerwasher.com.

Extension Cord length or gauge

incorrect

Use proper Extension Cord as instructed in section

..

Gun trigger not operating

properly

Contact us at:

[email protected]

or order a replacement directly online at:

www.huskypowerwasher.com.

Defective Gun

Remove the Gun and Hose assembly from the

front of the unit. Aim water stream away from

electric source and switch the unit into the ON

position. If the unit starts and water comes out

of the front, the Gun may need to be replaced.

Contact us at:

[email protected]

or order a replacement directly online at:

www.huskypowerwasher.com.

Tripped Pressure washer

Thermal Switch

Allow to cool and restart unit.

Defective ON/OFF Switch

Contact us at:

[email protected]

or order a replacement directly online at:

www.huskypowerwasher.com.

Unit will not stop when trigger

is released

Screen filter is clogged

Clean the Screen filter as instructed in the section

6..

Garden Hose is kinked or

leaking water

Make sure the Garden Hose is laid out flat and

there are no kinks in it. The hose should not be

wrapped on a storage wheel. Make sure the

faucet is open all the way and there is a full

volume of water reaching the unit.

Advertising