Harbor Freight Tools 42307 - Manual (Page 4)

SKU 42307 For technical questions, please call 1-800-444-3353. Page 4
or other part that is damaged should
be properly repaired or replaced.
DIRECTION OF FEED. Feed work
20.
into a blade or cutter against the
direction of rotation of the blade or
cutter only.
NEVER LEAVE TOOL RUNNING
21.
UNATTENDED. TURN POWER OFF.
Don’t leave tool until it comes to a
complete stop.
grOUNdiNg iNSTrUCTiONS
TO PrEVENT
ElECTriC SHOCk
ANd dEATH FrOM
iNCOrrECT grOUNdiNg
WirE CONNECTiON
rEAd ANd FOllOW THESE
iNSTrUCTiONS:
110-120 V~ double insulated
Tools: Tools with Two Prong
Plugs
Outlets for 2-Prong Plug
To reduce the risk of electric shock, 1.
double insulated equipment has a po-
larized plug (one blade is wider than
the other). This plug will fit in a polar-
ized outlet only one way. If the plug
does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact
a qualified electrician to install the
proper outlet. Do not change the plug
in any way.
Double insulated tools may be used
2.
in either of the 120 volt outlets shown
in the preceding illustration. (See
Outlets for 2-Prong Plug.)
Miter Saw Safety Warnings
For Your Own Safety read instruction
Manual Before Operating Miter Saw
Wear eye protection. 1.
Keep hands out of path of saw blade. 2.
Do not operate saw without guards in 3.
place.
Do not perform any operation free-
4.
hand.
Never reach around saw blade.
5.
Turn off tool and wait for saw blade 6.
to stop before moving workpiece or
changing settings.
Disconnect power before changing
7.
blade or servicing.
Return all guards to original position if
8.
any are moved during blade replace-
ment. Check all guards for proper
operation after service.
dO NOT OPErATE WiTH ANY
9.
gUArd diSABlEd, dAMAgEd,
Or rEMOVEd. Moving guards
must move freely and close in-
stantly.
The use of accessories or attach-
10.
ments not recommended by the
manufacturer may result in a risk of
injury to persons.
When servicing use only identical
11.
replacement parts.