Husqvarna 67521HVE - Manual (Page 5)

5
TO ASSEMBLE GRASS CATCHER
(See Figs. 3 and 4)
1. Slide grass catcher bag over the frame. Make sure
the rear handle is on top (the same side as the front
handle) and the strap is on the bottom.
2. Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold them in warm water
for a few minutes. If bag gets wet, let it dry before using.
3. Close grass catcher door.
NOTE: When fully closed, door will “snap” shut over frame
and vinyl bindings.
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a
mulcher. To convert mower to bagging or discharging,
see “TO CON VERT MOWER” in the Operation section of
this man u al.
TO PREPARE BATTERY (See Fig. 5)
NOTE: Your battery must be charged before you can start your
lawn mower.
1. Con nect battery charger con nec tor (male) to harness
con nec tor (fe male).
2. Plug battery charger into 110 volt A.C. outlet.
3. Leave battery charger connected for 24 hours before
starting your engine for the fi rst time.
4. After charging, disconnect harness connector (female)
from bat tery charger connector (male).
Connect your battery charger to charge battery after each
use.
IMPORTANT: The engine will not recharge your battery.
At the end of the mowing season the battery should be
charged for 48 hours to protect the battery during winter
storage.
CAUTION: Always disconnect the
en gine connector (male) from the
battery connector (female) to prevent
ac ci den tal start ing when transporting
or stor ing your lawn mower after the
season.
GRASS
CATCHER
FRAME
FIG. 4
VINYL
BINDINGS
DOOR
BAG
ASSEMBLY
FIG. 3
FRONT
HANDLE
REAR
HANDLE
STRAP
DOOR
FIG. 5
ENGINE CONNECTOR (MALE)
HARNESS
CONNECTOR
(FEMALE)
BATTERY CHARGER
CHARGER
CONNECTOR
(MALE)
BATTERY
BOX