Husqvarna LE475 / 966951101 - Manual (Page 7)

7
Before starting the engine, be sure the wheels
and cutterhead are positioned so the blade
will not strike the wheels.
CAUTION
Do not change wheel positions when engine
is running.
WARNING
CURB RIDING POSITION
Remove the spacer from between the front
wheels. Slide the right wheel toward the left wheel
and replace the spacer between the wheel and
right frame. Only vertical edging can be done in
this position.
WHEEL POSITIONING (See Fig. 4)
The wheel adjusting spacer should be centered
between the wheels when edging in the vertical
position. Wheels must be in the dual position
to the right when edging with cutterhead in an
angle position or trimming (horizontal position).
Remove the spacer from between the wheels
by lifting on spacer with open side down. Slide
the left front wheel on the axle toward the
right wheel, and once again install the spacer
on the axle between the frame and wheel.
NOTE: As pictured above, wheels are positioned
to the right for trimming. The wheels are positioned
to the left for curb riding edging.
NOTES
OPERATING YOUR EDGER-TRIMMER, CONT.
Wheel Spacer Positioned For Trimming
Fig. 4