Heath Zenith SL-4300 - Manual (Page 3)

3 598-1208-00
Ground Screw
White to White
Black to Black
Recommended Grounding Method
One Motion Sensing Light
Two Motion Sensing Lights (Working Independently)
Other Wiring Options
This fixture can be wired to control another stan-
dard or motion sensing light fixture(s). See the
following wiring diagrams for proper connections.
Note: All wiring should be run in accordance with
the National Electrical Code (Canadian Electrical
Code in Canada) through conduit or another ac-
ceptable means. Contact a qualified electrician
if there is any question as to the suitability of
the system.
Black to Black
White to White
Ground
to Ground
Black to Black
White to White
Ground to Ground
Metal Junction
Box
Pigtail (not
supplied)
Fixture Bare
Ground Wire
Bare Ground Wire
Wiring Motion Sensing Light to Control Standard
Fixture
Ground to
Ground
Standard Light Fixture Motion Sensing Light
Black to Black
White to White
Red to Black
Maximum Load for
Motion Sensor –
200 Watts
Maximum Lamp
Wattage Rating
for Light Fixture –
100 Watts
Maximum Lamp
Wattage Rating
for Light Fixture –
100 Watts
TOTAL Load for
Motion Sensor –
200 Watts
CONTROLLING Fixture
CONTROLLED Fixture 1
When controlling an additional light fixture(s), the
maximum wattage of the motion sensor on this
fixture should be observed. See illustration below
for an example of a maximum lamp wattage load
calculation.
IMPORTANT: When determining the maximum
lamp wattage rating of the fixture to be controlled,
refer to the maximum lamp wattage label on the
fixture and not the wattage rating on the lamp(s)
currently installed in the fixture.
Wiring Motion Sensing Light to Control Another
Motion Sensing Light
Black to Black
White to White
Ground to Ground
Black to Red
and Black
Red to Black
Controlled Motion
Sensing Light
Motion Sensing Light