Hoover SilentAir 2000 - Manual (Page 6)

5. If you have a problem
3-7
6
To remove ionization line:
Grasp one end of the line and gently
stretch it to release ring (I) from hook
(J).
Remove opposite ring from hook.
Service
To obtain approved service, call the
Hoover SilentAir Customer Service
Center at
1-800-473-8520 , OR
Visit our website at
www.silentair.com
If your air purifier is not operating normally, the cause may be easily found by
reviewing the list below.
• Unit not firmly plugged into electrical outlet.
•
Plug unit firmly into electrical outlet.
• No voltage in wall outlet.
•
Check fuse or breaker.
• Front cover not secure.
•
Check cover for proper placement.
Problem: Power light not on
Problem: Collection sheet stays clean yet power is on
Problem: Air purifier is noisy
• Ionization line is loose
•
Disconnect from electrical outlet and check ionization line.
• Air purifier is dirty
•
Disconnect from electrical outlet and clean ionization line, main body and
aluminum plates (Figs. 3-6 through 3-8)
• Air purifier is dirty
•
Disconnect from electrical outlet and clean ionization line, main body and
aluminum plates (Figs. 3-6 through 3-8)
• Replace collection sheet
Problem: Strong ozone odor
• Ionization level set too high
•
Set ionization control to a lower setting
• Collection sheet and/or purifier is dirty
•
Disconnect from electrical outlet and clean ionization line, main body and
aluminum plates (Figs. 3-6 through 3-8). Replace collection sheet.
To replace ionization line, slip the ring
at one end over the hook. Gently
stretch the line, holding the opposite
end, to place the other ring over the
opposite hook.
Replace front cover.
J
I
3-8
Turn air purifier off and disconnect
from electrical outlet.
Remove front cover as described for
replacing the collection sheet.
Carefully wipe clean the ionization
line (C), using a soft, lint-free cloth.
3-6
C
H
H
If desired, you may clean the collec-
tion plates (H) and the main body with
a slightly moistened cloth.
Allow air purifier to dry thorougly.