Hoshizaki KM-151BAH - Manual (Page 67)

62
18. SEPARATOR
1) Unplug the icemaker or disconnect the power source. Remove the Top Panel.
2) Hold both sides of the Separator and lift it up. The Bracket Shaft will shift to the
Notch.
3) Push the Separator toward the Evaporator to release it from the Shaft.
4) Lift down the Separator and pull it toward you.
5) Refit the Separator in the reverse order of the removal procedure. Check that the
Separator is fit correctly on the Shaft and can swing like a pendulum.
6) Plug in the icemaker or connect the power source.
Fig. 29
19. SPRAY TUBE, WATER SUPPLY PIPE, SPRAY GUIDE
1) Unplug the icemaker or disconnect the power source. Remove the Top Panel.
2) Push the Tabs on both sides to release the Spray Tube.
3) Remove the end of the Spray Tube from the Bracket.
4) Pinch and lower the Hose Clamp and disconnect the Hose. The Spray Tube is
easily cleanable by removing the black rubber cap on the end.
5) The Water Supply Pipe is located right under the Spray Tube. Remove the Water
Supply Pipe from the Evaporator, pinch and shift the Hose Clamp, and disconnect
the Hose.
Spray Guide
Spray Tube
Separator
* Move in arrow directions
to remove
Water Supply Tube