HHB comm HHB MDP500 - Manual (Page 23)

23
2. Press the F1 button until the track number that you
want to move is displayed. Then, press the F3
button to choose the destination track number of
the move function. In the example given in point 1,
‘TRK003’ will move to the ‘TRK002’ position.
3. Press the F2 button to move the track.
4. Once the move function has been completed,
‘Complete!’ will be displayed.
NOTE – If you want to cancel the move operation in the
middle of the procedure, press either F3 or the STOP
button. You can return the moved track back to its original
position by going through move function again.
You can label each MD disc and individual tracks with
alpha-numerical characters.
1. Press the EDIT button until ‘NAME INPUT?’ is
recalled.
2. Press F1 to choose the track number that you wish
to name. If you want to name the disc, rather than
a track, continue pressing F1 until ‘DISC’ appears
on the display.
3. Press F2 to set-up.
4. The digit furthest to the left on the display will start
blinking to indicate that the digit is ready to edit. If
the track or disc already had a title, this function
can be over-ridden with a new title.
5. Press the F1, AMS or AMS buttons to
scroll through available characters. Then press the
F3, REW or FF buttons to shift the editing digit.
Pressing PLAY clears all the characters and the
STOP button cancels the edit mode.
6. After you have completed entering the name, press
F2 to set-up.
The following characters (and space) are available for
naming discs and tracks:
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789
:;<=>?@^_`!"#$%&’()*+,-./
NOTE – Pressing F1 in play or stop modes will display
the disc name, while pressing F2 displays the current
track name.
NAME INPUT?
TRK001 YES TRK002
™
CHARA ^ SET SHIFT
▲ ▲ ❙
▲ ▲ ❙
DISC & TRACK NAMING
PDISC_OP.QXD 6/11/00 12:44 pm Page 24