Havis-Shields C-VS-1200-F250-1 User Manual
Always
4
INSTALL INSTRUCTIONS C-VS-1200-F250-1
Vehicle Specific Console
2008 FORD F-250, 350, 450 and 550 Pickup and Cab Chassis Trucks
TOOLS REQUIRED:
Ratcheting wrench Phillips Screwdriver
Metric/Standard Socket Set T-20 Torx Driver bit
7/16” Wrench 7 mm Socket or Driver
INSTALLATION HARDWARE:
QTY DESCRIPTION PART
#
1 ¼” X 1” Hex Bolt GSM33002B
5 ¼” X ½” Carriage Bolt GSM31999
6 ¼” Serrated Hex Flange Nut GSM30023
1 ¼” Flat Washer GSM31005B
3 #8 x ¼” Flat Head Phillips Screw GSM33178
1 Torx Screw Kit C-HK-1
All other hardware is pre assembled on console or OEM hardware is reused.
Always
!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use only hardware provided with install kit.
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html
or call
1-800-524-9900 and ask for technical support.
***Crew Cab trucks will require the removal of the air conditioning / heat duct
that runs on top of the transmission hump to rear seats. Installer will need to
block off remaining duct opening. Screws, foam and duct tape can be used to
close off duct. (Not included)***