Hearth and Home Technologies Square Termination Cap TS345 - Manual

HeatilHearth & Home Technologies Inc. • TS345 Square Termination Cap • 31446 Rev E • 04/07 1
TM TM
Models:
TS345
Square Termination Cap
Installation
Instructions
This chimney termination cap has been tested for use with specifi c Hearth & Home Technologies Inc. fi replaces. Check with
your local building code agency before you begin installation to ensure compliance with local codes, including the need for
permits and follow-up inspections. If you encounter any problems regarding code approvals, or if you need clarifi cation of
any of the instructions contained here, contact your Hearth & Home Technologies Inc. dealer. For the dealer nearest you,
please visit www.hearthnhome.com
Note: An arrow (¨) found in the text signifi es change in content.
Sharp Edges
• Wear protective gloves and safety
glasses during installation.
CAUTION
13-1/4 in.
(337 mm)
18 in.
(457 mm)
16-1/4 in.
(413 mm)
22 in.
(559 mm)
23-1/8 in.
(587 mm)
16"
Minimum
Field
Constructed
Shroud
Maximum
Height of 16"
Open
Top
Only
18¾"
Minimum
Roof Chase
3" air space
from bottom of
shroud to top
of chase
Dimensions for a Field Constructed Shroud
Figure 1 Figure 2
Fire Risk
• Intended for use with a metal chase
top.
Use of combustible materials will cause a
fi re hazard.
WARNING
¨
¨
¨