Hayter Mowers 21in Heavy-Duty Walk-Behind Rotary mower 455E - Manual (Page 7)

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
Handle 1
Bolt (5/16 x 7/8 inch) 2
Bolt (5/16 x 1-1/2 inches) 2
Washer 4
Locknut (5/16 inch) 4
1
Cable tie 3
Install the handle.
Self-tapping screw 2
2
Fuel tank 1
Install the fuel tank and fuel line.
3
No parts required – Fill the crankcase with oil.
Note: Determine the left and right sides of the machine
from the normal operating position.
1
Installing the Handle
Parts needed for this procedure:
1 Handle
2 Bolt (5/16 x 7/8 inch)
2 Bolt (5/16 x 1-1/2 inches)
4 Washer
4 Locknut (5/16 inch)
3 Cable tie
Procedure
1. Mount the handle to the mower housing with 2 bolts
(5/16 x 7/8 inch), 2 bolts (5/16 x 1-1/2 inches), 4
washers, and 4 locknuts (Figure 3).
Figure 3
1. Housing 3. Bolt (5/16 x 1-1/2 inches),
washer, and locknut
2. Handle 4. Bolt (5/16 x 7/8 inch),
washer, and locknut
Note: Install the washers with the cup side facing
the handle.
Note: You can adjust the handle height for more
comfortable operation. Securing the lower handle
end in the upper hole lowers the handle; securing the
lower handle end in the lower hole raises the handle.
2. Use the cable ties provided to secure the control
cables to the handle.
7