Honeywell HS-2007 Series - Manual (Page 3)

ASSEMBLY INSTRUCTIONS
• Place Base Extensions
(A) as illustrated and
snap Base Connector (B)
firmly onto Base
Extensions (Fig. 1).
• Insert the Adjustable
Pole (C) into the Base by
lining up the recessed
slot in the Pole to the
raised dot on the Base
Connector and push in.
Be sure that the Pole is
fully seated. Hold the
Base firmly and twist the
Pole CLOCKWISE 90°
until it stops. DO NOT
OVER-TIGHTEN (Fig. 2). • Adjust to the desired
height and tighten the
Height Adjustment Knob
(D) (Fig. 3).
ATTACHING THE MOTOR ASSEMBLY
TO THE FAN POLE
• Place the Motor
Assembly (E) onto the
Adjustable Pole and
screw into place by
turning Clockwise (Fig.
4). Align the slot to slide
the latch into place (Fig.
5). NOTE: The tilt angle
of the Motor Assembly
can be changed by
simply tilting the Motor
up or down.
• Remove the Blade
Knob (F) and the Rear
Grille Mounting Nut (G).
Place the Rear Grille (H)
onto theMotor Housing
by making sure the 3
holes of the Rear Grille
fit over the 3 bumps on
the Motor Housing.
Tighten the Rear Grille
Mounting Nut
CLOCKWISE. (Fig. 6)
Fig. 4
Fig. 5
Fig. 6
G
H
F
E
Fig. 1 Fig. 2
C
B
A
Fig. 3
D
HEIGHT
ADJUSTMENT KNOB
035-00449-000_R2 HS-2007 EFS 10/31/03 8:25 AM Page 3