Computer setup—exit, Model 505b/515b — computer setup (f10) utilities – HP 500B User Manual
Page 66
Computer Setup—Exit
NOTE:
Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table A-5
Computer Setup—Exit
Option
Description
Exit Saving Changes
Press
Enter
to exit saving changes.
Exit Discarding
Changes
Press
Enter
to exit discarding changes.
Load Setup Defaults
Press
Enter
to load setup defaults.
Discard Changes
Press
Enter
to discard changes.
Save Changes
Press
Enter
to save changes.
Model 505B/515B — Computer Setup (F10) Utilities
Use Computer Setup (F10) Utility to do the following:
●
Change factory default settings.
●
Set the system date and time.
●
Set, view, change, or verify the system configuration, including settings for graphics, audio,
storage, communications, and input devices.
●
View settings for processor and memory.
●
Modify the boot order of bootable devices such as hard drives, diskette drives, optical drives, or
USB flash media devices.
●
Restrict a device from booting the unit.
●
Run hard drive self-tests.
●
Establish a supervisor password that controls access to Computer Setup (F10) Utility and the
settings described in this section.
●
Enable or disable removable media boot ability.
58
Appendix A Computer (F10) Setup