HTC WIZA100 - Manual (Page 11)

Getting Started
|
11
3 Notification
LED 1
Bi-color LED on the left side: Blue for Bluetooth system
notification of powered-up and ready to transmit radio
frequency signal, and Green for Wi-Fi status.
- Blinking Blue indicates the device is in Bluetooth-
enabled mode.
- Blinking Green indicates the device is in Wi-Fi-enabled
mode.
Please note that Bluetooth and Wi-Fi features can
coexist on your device. If the two features are enabled
simultaneously, the LED will blink Blue and Green
alternately.
4 Speaker Listen to audio or a phone call from here.
5 Notification
LED 2
Bi-color LED on the right side: Green and Red for GSM
standby, SMS message, GSM network status, notification,
battery charging status.
- Blinking Green indicates the device connects to the
GSM network.
- Glowing Green indicates the battery is fully charged
(using the AC adapter).
- Blinking Red indicates the battery is low.
- Glowing Red indicates the device is in LDO charging
mode (the battery is empty).
- Blinking Amber (Green + Red) indicates there is
notification from the system.
- Glowing Amber (Green + Red) indicates the battery is
under charging by connecting the AC adapter.
6 Internet Explorer Press to launch Internet Explorer.
7 Messaging Launches the outlook (email) application.
8 Touch Screen Use to write, draw, or make a selection with the stylus.
9 Left SOFT KEY Performs the command shown in the label shown on the
Display Screen above the button.
10 Right SOFT KEY Performs the command shown in the label shown on the
Display Screen above the button.
11 END Button Press to end a call.
12 NAVIGATION
control
Press this multi-directional control up, down, left, or right
to move through menus, program instructions; carry out
the selection by pressing the center button.
13 TALK Button Press to answer an incoming call or dial a number.
14 Volume
Controller
Press up or down to adjust the volume. To adjust the
conversation phone volume, you must do it during a call.
Adjusting the volume at another time will affect the ring,
notification, and MP3 sound levels.
15 Comm Manager Press to start Comm manager; press and hold to switch to
vibration mode.