Hasbro Air-Powered Action Stadium 08628 - Manual (Page 3)

�������
������
Hockey Mode
- Press once for 5-point game
- Press twice for 7-point game
- Press three times for 10-point game
GETTING STARTED:
MODE SWITCH GAME SELECT BUTTON
Pinball Mode
- Press once for “Practice”
- Press twice for “
1 Player High Score Challenge”
- Press three times for “2 Player High Score Challenge”
TO INSTALL BATTERIES:
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow the toy and battery
manufacturers’ instructions;
2. Do not mix old and new batteries or alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference. Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to insert item correctly by matching
the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment.
Reset (switching off and back on again or removing and re-inserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always remove from the product before
recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
Use a Phillips/cross head screwdriver
(not included) to loosen screw in
battery compartment door (screw
remains attached to door). Slide door
and remove. Insert 4 x 1.5V “D” or
LR20 size alkaline batteries. Fit door
onto unit (tabs into notches), then
slide door to the left. Tighten screw.
NOTE - WHEN REPLACING BATTERIES:
Removing the batteries will clear the
high scores that have been stored in
the internal memory. All high scores
will be reset to zero after battery
replacement.
A two-position slide switch is
located below the Player One
goal as shown. This switch
will allow you to select
hockey or pinball mode.
Pressing this button will allow
you to cycle through different
games according to the position
of the mode switch.
GAME PLAY:
HOCKEY
1 . Make sure the mode switch is in hockey position.
2. Press the Game Select button to select the game of your choice (see Game Select button description above).
3. Once you have stopped on the game of your choice, the announcer will pause and then announce game start. The
air will turn on, and you are ready to play.
4. One player starts the game by placing a puck in the stadium and aiming for the goal.
5. When a goal is scored, the goal light will illuminate, and one point will be announced for the player who scored the
goal. “GOAL!” The toy will keep track of all points scored during the game.
6. During the game, when a player scores the final goal (5, 7 or 10 points depending on which game was selected) the
buzzer will sound and the winner and final score will be announced.
7. To play again, press the Game Select button to start or select a new game.
8. If you do not press the Game Select button within 3 minutes, the toy will shut off.
������
Note: Pressing and holding the Game Select button for 5 seconds during game play will turn the toy off.