HP 2307890A - Manual (Page 145)

Initial Configuration 139
Initial Configuration
Configuring audio for Media Center
To configure multichannel audio output for Media Center
audio:
1 Press Media Center on the remote control.
You can also click Start on the taskbar, and
select Media Center.
2 Click Settings, General, Media Center Setup,
and then Setup your Speakers. The Speaker
Setup screen displays.
3 Click Next.
4 Under Specify how many speakers you have, select
the speaker number that matches your system. For
example, select 5.1. Click Next.
5 Select the type of cable that connects your Media
Center audio receiver. For example, select Mini
plug (analog). Click Next.
6 Select Test. If you hear tones from all your speakers,
click Next. If you do not hear tones from all your
speakers, follow the onscreen instructions.
7 Click Finish.
Configuring audio for the DVD player
To configure multichannel audio output for the Media
Center DVD playback:
1 Press Media Center on the remote control.
You can also click Start on the taskbar, and
select Media Center.
2 Click Settings, DVD, and then Audio.
3 Select how many speakers you have under Speaker
Environment. Select your Output Mode, and Audio
Channel Expander, if needed. Set sound output to
match your speaker system. For example, select 5.1
for analog audio connections. If you have a digital
audio connection, select S/PDIF.
n
Reduce the volume level before changing
channels. Exercise particular caution when
changing from ATSC to NTSC channels. Your
analog NTSC channel audio levels may be
noticeably higher than your SD/HDTV
channel audio levels. The channel sound
volume is controlled by the content provider.
n
If your speaker configuration is not
displayed, click the Sound Effect (speaker)
icon in the desktop system tray.