HP PhotoSmart 812 - Manual (Page 41)

5-Connecting 41
Connecting
Connecting to a computer
Connect the camera to your computer to unload images. The
camera connects to your computer using a USB cable.
NOTE You can also connect your camera to a computer by
using the optional HP camera dock. See Connecting to
the HP camera dock later in this chapter.
NOTE If you are using a Macintosh computer, switch the
camera to Disk Drive in the USB Configuration menu
found in the Setup menu.
1 Connect the flat end of the USB
cable to the computer.
2 Open the rubber door on the side
of the camera, and connect the
round end of the USB cable to the
USB/TV connector on the
camera.
3 Turn the camera on. The HP
Image Unload software will
launch on your computer, and the
images in the camera will automatically unload to the
computer. If there were any images on the camera that had
been selected in the Share menu for printing or e-mail,
those actions are started after the images have been
unloaded to the computer.
4 When the unload screen says “Finished”, your images have
been saved and shared. You can now disconnect the
camera from the computer.
5