Hotpoint HDA3530 - Manual (Page 10)

Safety Information
Operating Instructions
Tr
oubleshooting T
ips
Customer Service
About the dial cycles.
Rinse & Hold
(HDA1100, HDA2000, HDA2020, HDA2030, HDA2120,
HDA2130, HDA2220, HDA3220, HDA3230, HDA3420, HDA3430, HDA3520
and HDA3530 only)
For rinsing partial loads that will be washed later. Do not
use detergent.
Make sure ENERGY SAVER / HEATED DRY OFF is selected.
Be sure the door is unlatched.
Slowly turn the Dial to RINSE & HOLD.
Latch the door to start the cycle. 4
3
2
1
OFF
ON
WATER SAVER
RINSE & HOLD
PLATE WARMER
(HEATED DRY OFF)
(HEATED DRY ON)
Plate Warmer (HDA2220, HDA3220, HDA3230, HDA3420, HDA3430,
HDA 3520 and HDA3530 only)
For warming clean dishes and serving plates. This cycle
will take approximately 32 minutes.
Load clean dishware to be warmed.
Select HEATED DRY / HEATED DRY ON.
Be sure the door is unlatched.
Slowly turn the Dial to PLATE WARMER.
Latch the door to start the cycle. 5
4
3
2
1
OFF
ON
WATER
SAVER
RINSE & HOLD
PLATE WARMER
(HEATED DRY OFF)
(HEATED DRY ON)
10
Delayed Start
(HDA3420, HDA3430, HDA3520 and HDA3530 only)
The HOURS DELAY will allow you to delay the start
time of any cycle not on the Dial automatically for up
to 6 hours.
Be sure the door is unlatched.
Select the wash cycle and option you want.
Slowly turn the Dial to desired time. The DELAYED
START
light will come on.
Latch the door to start the cycle. 4
3
2
1
HOURS
DELAY
OFF
RINSE & HOLD
PLATE WARMER
(HEATED DRY OFF)
(HEATED DRY ON)
START
6
4
2