Harbor Freight Tools 93874 User Manual
Page 8
SKU 93874
For technical questions, please call 1-800-444-3353.
Page 8
3.
WARNING! The warnings and precautions discussed in this manual cannot
cover all possible conditions and situations that may occur. It must be under
stood by the operator that common sense and caution are factors which cannot
be built into this product, but must be supplied by the operator.
State of California to cause cancer and birth defects and other reproductive
harm.
(California Health & Safety Code 25249.5, et seq.)
2.
WARNING! People with pacemakers should consult their physician(s)
before using this product. Operation of electrical equipment in close proximity to
a heart pacemaker could cause interference to or failure of the pacemaker.
UNPACKING
When unpacking, check to make sure all the parts shown on the Parts List on page 16
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
PRE-OPERATING INSTRUCTIONS
CAUTION! Always make sure the Gasoline Engine’s Power Switch is in its
“OFF” position prior to performing any service, maintenance, or cleaning of the
Compressor or Engine.
To Add Engine Oil:
1.
IMPORTANT! Prior to first using the Compressor, the Engine MUST be filled
with a high quality 10W-30 grade engine oil.
(See Engine manufacturer’s manual for complete instructions.)
2.
To do so,
unscrew
and remove the Engine Oil Dipstick. Pour approximately 3/4
quart of engine oil into the Dipstick Hole. Do not overfill.
3.
Clean the Oil Dipstick. Then screw the Dipstick fully back into the Dipstick Hole.
Unscrew and remove the Oil Dipstick again, and observe the level of engine oil
on the Dipstick. The oil level should appear between the “MINIMUM” and “MAXI-
MUM” indicator marks on the Oil Dipstick.
4.
If necessary, continue adding engine oil, while rechecking the Oil Dipstick, until
the oil level reaches the “MAXIMUM” indicator on the Oil Dipstick.
Do not exceed the “MAXIMUM” indicator mark on the Oil Dipstick.
5.
When finished adding engine oil, carefully screw the Oil Dipstick back into the
Dipstick Hole.