Honeywell Q179A - Manual (Page 2)

Q179A,B GAS PILOT BURNER ASSEMBLIES
60-2032—05 2
ORDERING INFORMATION
When purchasing replacement and modernization products from your TRADELINE® wholesaler or distributor, refer to the
TRADELINE® Catalog or price sheets for complete ordering number.
If you have additional questions, need further information, or would like to comment on our products or services, please write or
phone:
1. Your local Honeywell Automation and Control Products Sales Office (check white pages of your phone directory).
2. Honeywell Customer Care
1885 Douglas Drive North
Minneapolis, Minnesota 55422-4386
In Canada—Honeywell Limited/Honeywell Limitée, 35 Dynamic Drive, Toronto, Ontario M1V 4Z9.
International Sales and Service Offices in all principal cities of the world. Manufacturing in Australia, Canada, Finland, France,
Germany, Japan, Mexico, Netherlands, Spain, Taiwan, United Kingdom, U.S.A.
SPECIFICATIONS
Model Number:
Q179A—Gas pilot assembly with ignition and flame elec-
trodes. Use with intermittent or interrupted ignition. Ignition
electrode is for use with 6,000V grounded secondary-igni-
tion transformer. (Q179A1183 has ignition electrode [spark]
only.)
Q179B—Gas pilot assembly with flame electrode (rod) only.
Use with continuous pilot.
Burner:
Primary aerated. Stainless steel fins provide proper flame con-
tact area to ground area. Flame electrode and ground
bracket are furnished with each tip. Available tips are illus-
trated in Fig. 1, and listed in Table 1.
Mounting Means:
Bracket has holes for side mounting and two lugs for end
mounting.
Type of Gas:
Natural; for LP gas, order LP orifice separately (see
Accessories).
Gas Consumption:
Approximately two cu ft/hr.
Electrodes:
Stainless steel, maximum temperature 1750°F (954°C).
Electrode Insulator(s):
Ceramic.
Electrical Connector:
Rajah connector (both male and female supplied).
Approvals:
Underwriters Laboratories Inc. listed, File No. MP268;
Industrial Risk Insurers acceptable;
CSA certified, Master File No. LR-95329-1;
Factory Mutual approved;
American Gas Association certified, No. G140.401.
Mounting Dimensions:
See Fig. 2.
Maximum Temperature:
See Fig. 3.
Fig. 1. Pilot tip assembly styles.
A "I" PORT
B 45° "I" PORT
D 45° RIGHT HAND "ELL"
E 45° LEFT
HAND "ELL"
H 45° "T" PORT
G 45° "Y" PORT
F "T" PORT
M5007
1 NOTE THAT GROUND PRONG
IS CUT OFF CLOSE TO BASE.
1