haier WDNS121SS - Manual (Page 9)

START-UP INSTRUCTIONS
English
8
Read carefully and understand all installation instructions before
installing the water dispenser.
1. Remove the cap from the water bottle first. Lift up the water bottle and quickly
place it into the water receptacle. (The water bottle is not included.)
2. DO NOT plug in the water dispenser until you have checked that
water flows out of both faucets when the hot and cold water
release levers are pressed. Never turn on the water dispenser
without water. Doing so may cause the unit to catch fire or
malfunction.
3. Check that water flows out by pressing both the hot and cold water faucets
one at a time.
4. Plug the power cord into an 115volt / 60 Hz outlet.
5. To activate the water heater and cooler, press the hot water and cold water
switches to the ON position, the switches should be lit.