Harmar Mobility AL600 - Manual (Page 7)

Power Chair or Scooter
Preparation
AL600 & AL690
CHAIR / SCOOTER PREPARATION
ALA580
U-BOLT HARDWARE KIT
ANCHOR U-BOLTS:
THE U-BOLTS ARE TO BE USED WITH POWER CHAIRS OR SCOOTERS THAT DO NOT HAVE A CENTER SEAT POST.
ON THIS TYPE OF CHAIR, THE SEAT IS NORMALLY ATTACHED TO A TUBULAR FRAME. ATTACH THE U-BOLTS, TWO ON EACH SIDE,
TO THE FRAME AS SHOWN BELOW. MAKE SURE THAT THE LOOP EXTENDS TO THE OUTSIDE OF THE CHAIR TO ALLOW THE STRAP
HOOKS TO BE ATTACHED BY THE END USER.
EACH TYPE OF CHAIR WILL DIFFER SLIGHTLY AND THE PLACEMENT OF THE U-BOLTS WILL DIFFER BETWEEN DIFFERENT MODELS
AND MANUFACTURERS. PLACE THE ANCHOR U-BOLTS TOWARDS THE CENTER OF THE SEAT IF POSSIBLE. BECAUSE OF THE
DIFFERENT TYPES OF SEATS, YOU MAY BE FORCED TO ATTACH THE ANCHOR U-BOLTS MORE TOWARDS THE FRONT OR REAR OF
THE SEAT, BUT WE RECOMMEND ATTACHMENT AS CLOSE AS POSSIBLE TO THE CENTER OF THE SEAT.
KIT CONTAINS:
4 - 1/4-20 x 3-1/4” U-BOLTS
8 - U-BOLT BACKING PLATES
16 - SPLIT LOCK WASHERS
16 - 1/4-20 NUTS
SEAT
POST
SEAT
POST
SEAT
POST
SEAT
POST
THERE ARE 2 OPTIONS ON HOW TO ATTACH
THE STRAP HOOKS TO THE CHAIR
THAT ARE INCLUDED WITH THE LIFT.
THE ANCHOR PLATE IS A FLAT PLATE THAT IS 20” LONG WITH A SLOT IN EACH END.
THIS PLATE WILL WORK WITH ANY CHAIR OR SCOOTER THAT HAS A CENTER SEAT POST
AND ATTACHES TO THE BOTTOM OF THE SEAT.
ATTACH THE ANCHOR PLATE BY THE FOLLOWING STEPS:
ANCHOR PLATE:
1. REMOVE SEAT FROM THE CHAIR.
2. LOOSEN THE SCREWS THAT ATTACH THE PLATE TO THE BOTTOM OF THE SEAT. ALLOW ENOUGH ROOM
TO SLIDE THE ANCHOR PLATE BETWEEN THE SEAT AND SEAT PLATE.
3. ATTACH THE ANCHOR PLATE IN THE CENTER OF THE SEAT PLATE WITH THE HOLES ON EACH END
EXTENDING EVENLY ON EACH SIDE OF THE SEAT.
4. RE-TIGHTEN THE SCREWS THAT HOLD THE SEAT PLATE TO THE BOTTOM OF THE SEAT.
5. REPLACE THE SEAT ON THE CHAIR.
THE ANCHOR PLATE SHOULD EXTEND ABOUT 1-1/2” OUT FROM THE SIDE OF THE CUSHION.
THIS WILL ALLOW THE USER TO ATTACH THE STRAP HOOKS TO THE ANCHOR PLATE TO SECURE
THE CHAIR TO THE LIFT.
7