Harbor Freight Tools 94192 User Manual
Page 3
Page 3
SKU 94192
For technical questions, please call 1-800-444-3353
10.
Maintain tools with care. Keep tools sharp and clean for better and safer
performance. Inspect tool cords periodically and, if damaged, have them repaired by
an authorized technician. The handles must be kept clean, dry, and free from oil and
grease at all times.
11.
Stay alert. Watch what you are doing, use common sense. Do not operate any tool
when you are tired.
12.
Check for damaged parts. Before using any tool, any part that appears damaged
should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment and binding of moving parts; any broken parts
or mounting fixtures; and any other condition that may affect proper operation. Any
part that is damaged should be properly repaired or replaced by a qualified
technician.
13.
Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use accessories
intended for use with this tool. Approved accessories are available from Harbor
Freight Tools.
14.
Do not operate tool if under the influence of alcohol or drugs. Read warning
labels if taking prescription medicine to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not operate the tool.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure the following parts are included. Refer to the Parts
List and Assembly Drawing at the end of this manual. If any parts are missing or broken,
please call Harbor Freight Tools at the number on the cover of this manual as soon as
possible.
Installation
Caution: The 13 HP Generator (SKU 94191) weighs 175 lbs. Always have help when
lifting or moving it. Allow the Generator to cool before Wheel Kit installation. Disable
motor.
For ease of installation of the Wheel Kit, refer to the Assembly Drawing at the end of this
manual.
1.
With the help of another person, lift the Generator and rest it on a sturdy support (see
description below) able to hold the weight of the Generator.
The support should be at least 12 inches deep by four feet wide, by at least 10 inches
high, i.e., wooden beam. It should rest flat on the work surface. When placed, the
Generator must be stable, not wobble.