Hamilton Beach 19031 - Manual (Page 3)

5
Auto Shutoff Reset Button/Light
The light comes on when the iron is first
plugged in. After 15 minutes, the iron will
shut off and the light will go out. Push
the Reset Button to turn the iron back
on.
Power On Light
This light comes on when the iron is
plugged in and remains on until the iron
is unplugged. The light stays on even if
Temperature Control Dial is turned to Off.
Spray and Blast of Steam Buttons
Push Blast Button for an extra blast of
steam. Push Spray Button to release a
fine spray of water for difficult wrinkles
in cotton or linen.
Reset
Button
Light
Features
Power
Light
4
To Dry Iron
1. Plug iron into outlet.
2. Set the Adjustable Steam Switch to
O (the Dry Iron position).
3. Turn Temperature Control Dial to
desired temperature. Allow two
minutes for iron to reach desired
temperature.
4. To turn iron Off, turn Temperature
Control Dial to Off and unplug iron.
1. Unplug iron. Using a cup, slowly pour 5 ounces of tap
water into water tank opening. Do not fill iron directly from
the faucet.
2. Plug iron into outlet.
3. Turn Temperature Control Dial to desired fabric setting in
steam range. Then set Adjustable Steam Switch to the
recommended steam level.
4. Allow two minutes for the iron to reach desired temperature.
5. To turn iron off, set Adjustable Steam Switch to O (Dry
Iron). Turn the Temperature Control Dial to Off. Unplug iron.
6. Empty water from the iron following directions in “Caring
for Your Iron.”
To Steam Iron
Blast Spray
840101400 ENv02.qxd 5/10/02 1:28 PM Page 4