HP D6028-90004 - Manual (Page 34)

Chapter 4 Setting Up the Remote Connection
28
download the desired version onto your card. Note that once you select "Start
Firmware Update" the update begins immediately.
HP TopTools Remote Control for HP NetServers - Firmware Update Settings
<S> Start Firmware Update
<F> Set Firmware Image Filename firmimg.bin
<A> Set IP-Address of Firmware TFTP Server 127.0.0.1
<M> Main Menu
Figure 4-6. Preparation for Firmware Update
After firmware update is finished you will be prompted to reboot the card, so the
new settings can take effect.
NOTE If you don’t see this prompt or the connection to the HP
TopTools Remote Control card is interrupted during the
firmware update, repeat this update before rebooting the card.
Setting Up a LAN Connection
You can communicate with remote clients by connecting to your local 10Base-T
compatible network using the RJ-45 jack located at the rear bracket of the HP
TopTools Remote Control card and an appropriate cable.
The following figure illustrates a LAN connection joining an HP NetServer (with
HP TopTools Remote Control card) and a remote client.
Office
LAN jack
Remote Client
HP TopTools
Remote Control
card to 10Base-T
or 10/100 Hub
RJ-45
cable
Figure 4-7. Remote Connection via the LAN