Harbor Freight Tools 66552 - Manual (Page 3)

SKU 66552 For technical questions, please call 1-800-444-3353. Page 3
do not overreach. keep proper c.
footing and balance at all times.
This enables better control of the tool
in unexpected situations.
dress properly. do not wear loose
d.
clothing or jewelry. keep your
hair, clothing and gloves away
from moving parts. Loose clothes,
jewelry or long hair can be caught in
moving parts.
only use safety equipment that
e.
has been approved by an appropri-
ate standards agency. Unapproved
safety equipment may not provide
adequate protection. Eye protection
must be ANSI-approved and breath-
ing protection must be NIOSH-ap-
proved for the specific hazards in the
work area.
Motocross bike stand
safety Warnings
Strap load to Saddle before lifting. 1.
Keep clear of Release Bar and do not 2.
leave unattended while supporting
load.
Do not exceed 350 lb. capacity.
3.
Center load on Saddle. 4.
Raise and lower using second person 5.
to stabilize load.
Keep out from under load while low-
6.
ering.
Inspect before every use; do not use
7.
if parts are loose or damaged.
Use as intended only.
8.
Operate on flat and level surface. 9.
Do not rock load on Stand. 10.
Keep out of reach of children. 11.
Maintain labels and nameplates on 12.
the tool. These carry important safety
information. If unreadable or miss-
ing, contact Harbor Freight Tools for a
replacement.
The warnings, precautions, and in-
13.
structions discussed in this instruction
manual cannot cover all possible con-
ditions and situations that may occur.
It must be understood by the operator
that common sense and caution are
factors which cannot be built into this
product, but must be supplied by the
operator.
saVe tHese
instructions.