Hyundai 21 Series - Manual (Page 9)

Specification
Specifications
MAIN
SUB
i i
Controller Controller
Controls
Spindle Functions
Programming Functions
Feed Functions
Reference Functions
FANUC 0
i
-T
Controlled Axes 2(X, Z) axes. (Max. 4 axes are available) Max. 4(X, Z, B and C) axes
Simultaneous Controllable Axes 2 axes / Linear and circular. (Max. 4 axes) Max. 4(X, Z, B and C) axes / Linear and Circular
Least Input Increment X axis : 0.001mm (0.0001 )
Z axis : 0.001mm (0.0001 )
C axis : 0.001deg.
Least Command Increment X axis : 0.001mm (0.0001 )
Z axis : 0.001mm (0.0001 )
C axis : 0.001deg
Spindle Speed Command S5 digits, Binary Output
Spindle Speed Override 50% ~ 150% (10Steps)
Spindle Orientation (1 Position) Provided
Maximum Programmable Dimensions +/- 9999.9999
Interpolation Functions Positioning/ Linear/ Circular (G00/G01/G02/G03)
Cylindrical Interpolation - Provided
Absolute and Incremental Command G90 ~ 91
Constant Surface Speed Control G96 SXXXX
Decimal Point Input Provided
Direct Drawing Dimension Programming Provided
Miscellaneous Function M2
Canned Cycle : G90, G92, G94 Turning, Threading, Facing
Multiple Canned Cycle : G70 ~ G72, G74 ~ F76 Finish, Rough, Peck Drilling, Grooving, Threading
Multiple Canned Cycle : G80 , G83, G83 ~ G88 - Deep Hole Drilling, Tapping and Boring for X & Z
Rigid Tap - Provided
Program Stop M00, M01
Program End M02, M30
Programmable Data Input (G10) Provided
Manual Jog Feed : Rapid, Jog, Feed, Handle Provided
Manual Handle Feed-rate x1, x10, x100
Feed Command F code Feed-rate Direct Command
Feed-rate Override 0 ~ 200% (21 Steps)
Jog Override 0 ~ 2,000mm/min [79 ipm] (21 Steps)
Rapid Traverse Override F0, F5, F25/F50, F100%
Override Cancel Provided
Dwell G40, 0 ~9999.9999 sec
Manual Continuous Feed Simultaneous, 1 Axis
Jog- Handle (Same Mode) Provided
Incremental Feed X1-1000
Manual Reference Point Return Provided
Automatic Reference Point Return G28, g29
Reference Point Return Check G27
Second Reference Point Return G30
SKT15/21
Series