Heat & Glo Fireplace LUX60 - Manual (Page 51)

Heat & Glo • LUX60 • 4062-116 • Rev. G • 4/11 51
IMPORTANT! This appliance should be run
three to four hours on low on the initial start-up.
Turn it off and let it cool completely. Remove and
clean the glass. Reinstall the glass and run the
appliance for an additional 12 hours. This will
help cure the products used in the paint.
D. Install Glass Rock
• Thirty pounds of black glass rock is provided with this
appliance.
Figure 15.8 Install Glass Rock
NO ROCK IN THIS AREA!
Figure 15.9 DO NOT Block Ports!
WARNING! Risk of Fire or Explosion! DO NOT cover
burner ports with rock. This could prevent cross-over igni-
tion, resulting in delayed or no ignition to this burner.
Note: Rinse the glass rocks with clear water and allow
to dry before installation.
• Spread glass rock evenly across hearth pan to just cover
metal pan. See Figure 15.8.
• Ensure that no glass rock is blocking any ports on burner
tubes. The area between the rock shield and the back
burner tube MUST be kept open as shown in Figure 15.9.
WARNING! Choking Hazard! Keep glass rock out of
reach of children.