Havis-Shields 1995-2007 Ford Crown Victoria Trak-Mount Kit C-TM-CV User Manual
Install instructions c-tm-cv
INSTALL INSTRUCTIONS C-TM-CV
1995-2007 FORD CROWN VICTORIA TRAK-MOUNT KIT
TOOLS REQUIRED:
Ratcheting
Wrench
Metric Socket Set
Standard Socket Set
Tape Measure
HARDWARE:
QTY DESCRIPTION PART#
10
¼” x ¾” Hex head bolt
GSM33001
6 ¼”
Serrated
nut
GSM30023
4
¼” Flat washer
GSM31005
4
¼” Split lock washer
GSM31026
SUB ASSEMBLY:
1. MOUNT TRAK TO HUMP BRACKETS.
• Determine location that Trak will land on transmission hump for the specific
application.
• With Trak in necessary location, measure Front and Rear Hump Bracket in relation to
Trak.
• Bolt trak to the front hump bracket, top plate using measurements taken in previous
step. Use (4) ¼-20 x ¾” Hex head bolts and serrated nuts.
Note: There are 2 different sides to the Trak Plate. It is recommended to mount Hump brackets to
side of Trak Plate that has ¼” hardware slots closer together, to better accept equipment, (consoles,
control heads, etc)
Trak Mount
Rear Hump
Brackets (C-B16)
Front Hump
Bracket (C-B33)
¼” Hardware
Slots
TRAK-MOUNT ASSEMBLY