Hampton Direct Hawkins 44 in Ceiling Fan 122 135 - Manual (Page 10)

8
Installing the
Light Kit
While holding the light kit assembly under your
fan, locate two single white and blue wires in
the switch housing labeled FOR LIGHT. Make
the polarized plug connections:
- White to white
- Blue to black
Carefully push all wires back into the switch
housing. Attach the light kit fitter by aligning its
keyhole slots with the three screws holes and
reversing switch on the side of switch housing.
Tighten the three screws securely to prevent the
light kit from vibrating loose.(Fig. 12)
Install 3 x 40W candelabra bulbs (included).
Place glass shade over the light kit stem, secure
with the metal nut (rubber side on the top). Do
not overtighten.
Insert the 2 pull chain through the eyelet in the
shade and cap. Secure the glass cap and decora-
tive nut provided. Do not overtighten. (Fig. 12)
1.
2.
3.
4.
5.
Fan without Light Kit
(Optional)
Your fan is designed with light kit, in case you
intend to install the fan without light kit, attach the
switch housing cover to the switch housing with
the screws provided. (Fig. 13)
Switch Housing
Screws Switch Housing
Cover
Figure 13
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT RETAILER.
NOTE
MAKE SURE TO LEAVE ENOUGH SPACE
BETWEEN THE FAN PULL CHAIN AND THE
BULBS SO THE CHAIN DOESN'T RUB AGAINST
ANY OF THE BULBS.
NOTE
BEFORE STARTING INSTALLATION, DISCONNECT
THE POWER BY TURNING OFF THE CIRCUIT
BREAKER OR REMOVING THE FUSE AT FUSE
BOX. TURNING POWER OFF USING THE FAN
SWITCH IS NOT SUFFICIENT TO PREVENT
ELECTRIC SHOCK.
Screws
Pull Chains
Switch Housing
Bulbs
Glass
Shade
Metal Nut
Glass Cap
Decorative Nut
Wire Connectors
Light Kit
Assembly
Figure 12