HP CM6049F MFP - Manual (Page 213)

6. To replace a DIMM that is currently installed, spread the latches apart on each side of the DIMM
slot, lift the DIMM up at an angle, and pull it out.
XO XO XO XO XO XO
XOXOXOXOXOXO
XOXO XOXO XO
XOXO XOXO XO
XOXO XOXO XO
XOXO XOXO XO
XOXOXOXOXOXO
XOXO XO XO XO
XOXOXO
XOXOXO
XOXOXO XOXOXO
XOXOXO XOXOXO XOXOXO XOXOXO XOXOXO
XO XO XO
XO XO XO
XOXOXOXO XO XO XO
XO XO XO
XOXOXO
7. Remove the new DIMM from the antistatic package. Locate the alignment notch on the bottom
edge of the DIMM.
8. Holding the DIMM by the edges, align the notch on the DIMM with the bar in the DIMM slot at an
angle and firmly press the DIMM into the slot until it is fully seated. When installed correctly, the
metal contacts are not visible.
XO XO XO
XO XO XO
XOXOXOXOXOXO
XOXO XOXO XO
XOXO XOXO XO
XOXO XOXO XO
XOXO XOXO XO
XOXOXOXOXOXO
XOXO XO XO XO
XOXOXO
XOXOXO
XOXOXO XOXOXO
XOXOXO XOXOXO
XOXOXO XOXOXO XOXOXO
XO XO XO
XO XO XO
XOXOXOXO XO XO XO
XO XO XO
XOXOXO
9. Push down on the DIMM until both latches engage the DIMM.
XO XO XO XO XO XO
XOXOXOXOXOXO
XOXOXOXOXOXO
XOXO XO XO XO
XOXOXO
XOXOXO
XOXOXO XOXOXO
XOXOXO XOXOXO XOXOXO XOXOXO XOXOXO
XO XO XO
XO XO XO
XOXOXOXO XO XO XO
XO XO XO
XOXOXO
XIO XIO XIXO
OX IX O
XIO XIO
XIO XIO XIXO
OX IX O
XIO XIO
XIO XIO XIXO
OX IX O
XIO XIO
XIO XIO XIXO
OX IX O
XIO XIO
NOTE: If you have difficulty inserting the DIMM, make sure the notch on the bottom of the DIMM
is aligned with the bar in the slot. If the DIMM still does not go in, make sure you are using the
correct type of DIMM.
ENWW Replace supplies 197