Hotpoint SDW80 - Manual (Page 8)

8
Rinse aid.
This product makes dishes
sparkle more as it improves
their drying. The rinse aid
container is situated on the
inside of the door: It should
be filled up when the low
rinse aid indicator light "U"
flashes on the display.
Adding rinse aid.
To open the dispenser, turn
cap C anticlockwise. Take
care when you pour in the
rinse aid to avoid it
overflowing.
The detergent
Each time you load the
dishwasher, add
detergergent. Pour
dishwasher detergent into
thedispenser on the inside
of the door.
Adding detergent
To open lid A, press button
B.
The detergent should be put
into the two containers C and
D.
If using a tablet, put it in
container "D".
Now you can close the lid:
press it down until you hear
it click.
If it won't close
Check whether there is any
detergent residue on the
edges of the dispenser.
Remove the excess.
You can regulate the amount of rinse aid used by the
dishwasher, move the adjuster F which you will find under
lid C.
You can choose from six different positions. It is normally
set to 4.
Before Using your Dishwasher
- The amount of rinse aid
needs to be increased if
the dishes appear dull or
you can see circular stains.
- The amount of rinse aid
needs to be reduced if the
dishes are sticky or you
can see white streaks.
• Use the right amount of
detergent (see programme
chart).
• Store your detergent and
rinse aid in a cool, dry place,
safely away from children.
B
D
C
A
F C
Warning
Three-in-one dishwasher tablets are now available on the market, and combine detergent, salt and rinse aid all in one.
If the water in your area is hard or very hard, we still recommend you pour extra salt into the relevant dispenser to prevent the
formation of white streaks on your dishes or on the interior of the appliance.
Using a three-in-one product means it is no longer necessary to put rinse aid into the relevant container.
If you want to achieve perfectly dry dishes, you may add rinse aid as long as the dosage adjuster is set to no.2.
In any case, please read the manufacturer's instructions on the packet.
If you use only these products, it is normal for the salt and rinse aid indicator lights to flash permanently after a certain number of
cycles.
To obtain the best
results from each washing
and drying cycle, powder
detergent, rinse aid liquid
and salt should be used.