HP 2500n - Manual (Page 35)

ENWW Chapter 2 Printing tasks 33
Loading optional tray 3
The optional tray 3 supports A4- and letter-size paper. Optional tray 3
supports only paper, but paper includes average-weight letterhead and
prepunched paper.
For additional information about letterhead and prepunched paper, see
“Printing on letterhead or preprinted forms” on page 47 .
CAUTION
Print special print media such as labels and grayscale transparencies
from tray 1 only. Printing special print media from optional tray 2 or
optional tray 3 can cause jams.
To load optional tray 3
1 Pull the tray out of the printer and remove any paper.
2 For letter-size paper, pull the rear stop up. For A4-size paper, push
the rear stop down.
3 For letter-size paper, move the side width guides outward as far as
possible. For A4-size paper, move the side width guides inward as
far as possible.
4 Load the paper. If this is special paper such as letterhead, load it
with the side to be printed down and the top edge toward the front of
the tray.
Note
If you are manually duplexing, see “Printing on both sides (duplexing
manually)” on page 48 for loading instructions.
5 Make sure the stack of paper is flat in the tray at all four corners,
and keep it below the height tabs on the length guide in the rear of
the tray.
6 Slide the tray back into the printer.
1
2
3
5
4
6