Heath Zenith 598-1109-06 - Manual (Page 2)

-2- 598-1109-06
5. Mount push button. Use either screws or double sided
tape to mount push button.
•
Screw Mounting: To mount with screws, remove
back of case by pushing in tab on bottom with a small
screwdriver (see Figure 1). Note: Remove material in
screw holes (if needed) before mounting with screws.
Attach back of case to door jamb or wall (see Figure
4). Snap front of push button on.
• Tape Mounting: When attaching push button using
double sided tape, make sure the surface of the door
jamb or wall is clean.
6. Mount chime. Determine mounting location.
There are three different ways to mount the chime
depending upon the model of chime purchased. De-
termine which model you purchased below. Mount the
chime according to the instructions for your chime.
Basic Chime with Separate Chime with Attached
Chime Decorative Cover Decorative Cover
Style of push button and chime may vary from illustration.
Figure 4