Heath Zenith 5213 - Manual

© 2005 DESA Specialty Products™ 595-5734-04
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Photocell keeps the lighting off during daylight
hours.
Requirements
• The Light Control requires a properly installed and
working light fixture, operating on 120 volts AC.
• If you want to use Manual Mode, the fixture must be
wired through a switch.
OPERATION
Instant Motion Sensor
Light Control
Models 5212 and 5213
Parts
Package includes:
• Motion Sensor
• Lamp Adapter (5213)
• Two mounting screws
Existing Light Fixture
Sensor
Module
Sensor
Cord
Typical Installation
The lamp module should only be used with Listed lamp
fixtures. Never use a light bulb with a higher wattage
rating than the rating of your fixture.
10 5 1 TEST
ON-TIME
TEST
* resets to Auto Mode at dawn.
ON-TIME
AUTO
... back on.
1 Second OFF
then...
MANUAL OVERRIDE
10 5 1 TEST
Mode Switching Summary
Flip switch off for
one second then
back on
Move ON-TIME Switch
to 1, 5 or 10 minutes
MANUAL MODE
AUTO
TEST
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the cali-
bration time the control will be in the AUTO mode.
Lamp Adapter
Floodlamp
(not included)
Mode: On-Time: Works: Day Night
Test 5 Sec x x
Auto 1, 5, 10 min. x
Manual Until Dawn* x
Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
Manual mode works with the ON-TIME
switch in the 1, 5, or 10 position.
Put the ON-TIME switch in the 1, 5
or 10 minute position.
Put the ON-TIME switch on the bottom
of the sensor in the TEST position.