Honeywell GALAXY 16103 - Manual (Page 8)

4
Wireless Keyfobs
Keyfobs are portable controllers that can
be attached to a key ring. They will allow
you to Set and Unset the system by a
single press of a button and can some-
times be programmed with additional
functions. Because they operate by radio,
they can be used anywhere around the
premises provided that they are within
range of the installed radio receiver.
NOTE: Labels are provided to place over
the buttons to indicate the function.
Setting the System — Full Set
To set the system, make sure all doors are closed and windows are secure. The system cannot
be set if there has previously been an alarm which has not been reset.
To set the entire system:
Keypad:
Type your PIN code
then press [A] Wireless Keyfob:
Press [ON] button
Prox Tag:
Hold the tag in front
of the prox symbol for 3
seconds
The exit timer will begin and there will be a constant tone. Leave by the agreed exit route and
close the door. When the exit timer expires, there will be a 5 second settle period and then two
beeps will confirm the completion of setting.
If you hear a rapid beeping sound, the system cannot set as there are open zones. The keypad
will show which zones are open.
Open Zone Open Zone Open Zone Open Zone Open Zone 1044 1044 1044 1044 1044
The setting procedure can be cancelled at any time during the exit time by pressing the esc key
on the keypad, the [OFF] button on the keyfob or placing the tag back in front of the prox
symbol.
NOTE: Display not shown when
using wireless keyfobs to set
the system.
FULL SET 060 FULL SET 060 FULL SET 060 FULL SET 060 FULL SET 060