Holland XL-AR452 - Manual (Page 2)

2 XL-AR452 Rev. C
TABLE OF CONTENTS
Introduction...............................................................................2
Warranty ....................................................................................2
Notes, Cautions, and Warnings...................................................2
Installation Preparations ............................................................3
Installation .................................................................................3
Plumbing Diagram .....................................................................5
Parts List.....................................................................................5
Operating Instructions...............................................................6
Contact Information ..................................................................8
INTRODUCTION
This manual provides you information necessary for the
installation, adjustment, inspection, and safe operation of the
Holland air release feature for Trailer Sliding Suspensions.
No more pulling. New Air release effectively retracts and engages
slider pins with the pull/push of a knob. For added simplicity,
the Air Release operates with a proven design air brake chamber
just like current braking systems.
No training is required and faster slide relocation is enabled by
the simple switch operation.
To adjust the slide, the driver must park on level ground and set
all the brakes.The driver reloactes the stop bar to the desired
location and pulls out the Air Release knob located on the front
of the slider. The air brake chamber then releases the pins and
locks in the out position to allow movement.When pins have
released the driver slowly repositions the tractor until slide
contacts the manual stop bar. Set tractor brakes after positioning
is complete. Push in the knob and pins automatically engage and
lock into place.
The driver must check to ensure lock pins extend through upper
rail.As an added measure of safety, the stop bar must be relocat-
ed 1 hole behind slider before operating the vehicle.
For added driver safety, the Air Release only works when the
parking brake is set and is connected to the air supply with a
valve to prevent draining.
Air Release is available on all models of Holland slides - new and
retrofit. Optional manual back up also is available.
WARRANTY
Refer to the complete warranty for the country in which the
product will be used.A copy of the written warranty is included
with the product as well as in the suspension catalogs and on
the Holland Group Web Site (www.safholland.us).
It may also be ordered directly by calling 1-888-396-6501.
NOTES, CAUTIONS,
AND WARNINGS
You must read and understand all of the safety procedures
presented in this manual before starting any work on
the suspension.
Proper tools must be used to perform the maintenance and
repair procedures described in this manual. Many of these
procedures require special tools.
Failure to use the proper equipment could result in
personal injury and/or damage to the suspension.
Safety glasses must be worn at all times when
performing the procedures covered in this manual.
Throughout this manual, you will notice the terms “NOTE,”
“IMPORTANT,”“CAUTION” and “WARNING” followed by impor-
tant product information. So that you may better
understand the manual, those terms are as follows:
NOTE: Includes additional information to enable accurate
and easy performance of procedures.
IMPORTANT: Includes additional information that
if not followed could lead to hindered
product performance.
Used without the safety alert symbol,
indicates a potentially hazardous situation
which, if not avoided, may result in
property damage.
Indicates a potentially hazardous situation
which, if not avoided, may result in minor
or moderate injury.
Indicates a potentially hazardous situation
which, if not avoided, could result in death
or serious injury.