Honeywell TS33 - Manual (Page 7)

12 11
TEMPERATURE AND HUMIDITY SCANNING
Press and hold CHANNEL button for 2 seconds
– the indoor, channel 1, channel 2 and 3 readings will be
displayed in sequence automatically.
LOST COMMUNICATIONS
If the main unit display for the remote sensor goes blank,
press and hold [ ] button for 2 seconds to begin a new signal
search. If the signal still isn’t received, please make sure that:
1. The remote sensor is in its proper location.
2. The distance between main and remote units is not
over 100 feet.
3. The path between the units is clear of obstacles. Shorten the
distance between units if necessary.
4. Fresh batteries are installed correctly in both remote and
main units.
Note: When the temperature falls below freezing, the batteries
in outdoor remote sensors may have reduced voltage supply
and a shorter effective range. We recommend to
Use lithium-ion batteries at the temperatures below 32°F
If everything listed above is in order and there is no reception
anyway, please perform the following steps:
1. Bring main unit and remote sensor close together.
2. Remove 4 small screws from the back of the remote sensor
and open the battery compartment.
3. Remove the batteries from the battery compartment and
reinstall them in the same manner. Remote sensor
LED indicator will flash showing transmission of the signal.
4. Remove the batteries from the main unit and reinstall
them in the same manner.
5. On the main unit select the same channel number as
set on the remote sensor. Outdoor temperature
on the display will show that transmission is being
received successfully .
WEATHER FORECAST
The weather station is capable of detecting atmospheric
pressure changes. Based on collected data, it forecasts the
weather for the next 12 to 24 hours.
NOTE:
1. The weather forecast accuracy is approximately 70%.
2. Display shows forecasted, not current conditions.
3. The “Sunny” icon indicates clear weather, even when
displayed during night-time.
Forecast is... Sunny
Partly
Cloudy
Cloudy Snowy Rainy
When the
display
shows...
Indicator
displayed
on the unit
Temperature
Range
Humidity
Range
Shows
Current
Environment
COM
WET
DRY
No
Indicator
40%RH-
70%RH
OVER
70%RH
Below
40%RH
40%RH
to
70%RH
Ideal range for
both relative
humidity and
temperature
Contains excess
moisture
Contains
inadequate
moisture
No comment
20˚C to 25˚C
(68˚F to 77˚F)
-5˚C -+ 50˚C
(23˚F - 122˚F)
-5˚C -+ 50˚C
(23˚F - 122˚F)
Less than
20˚C (68˚F) or
More than
25˚C (77˚F)