Haan QUICKPRO TS-30 - Manual (Page 11)

www. HAANUSA.com 877-HAAN DIRECT / 877-422-6347 pg 9
Using Your QuickPro ™ Portable Steamer & Sanitizer
Operating Instructions: (cont)
• rain water
• boiled, filtered or bottled water
• water from refrigerators, batteries or air conditioners
• use distilled or demineralized water only as advised
on page 7.
using the Combination Lint/Nap Brush Accessory Attachment:
1) Before plugging the appliance in and while the Steam Plate
is cool, attach the Combination Lint/Nap Brush Accessory by
snapping it onto the Steam Plate.
2) On the both sides of the QuickPro ™ you will see two (2) raised
ridges near the Steam Plate (Fig 7). These correspond to the
clip tabs on the accessory (Fig 8).
3) Push the Combination Lint/Nap Brush Accessory onto the
Steam Plate until the clip tabs snap securely onto the ridges.
This allows the Steam Jets clear access to help freshen the
fabric (Fig 9).
4) Plug in the QuickPro™, wait for the Indicator light to turn Red
and then use the appliance as described in Step 10 of the previous
section. Use the textured surface of the accessory to remove
hair, dust or lint from garment surfaces as you steam. The
brush bristles can be used to freshen and lift the nap on the
fabric as you sanitize the surface.
5) The QuickPro ™ can be used to remove most fresh, wet spills and
stains from fabrics. Hold the Steam Plate over the fresh stain and
use the steam jets to penetrate the area. Use the Brush bristles to
rub the saturated area gently. Take an absorbent towel and blot
the area. Repeat as necessary until the stain is lifted.
6) When finished using the QuickPro™, unplug the unit and allow
the appliance to cool completely while on the Metal Resting Tray.
Remove the accessory attachment; it will snap off easily. Empty
any residual water in the reservoir before storing the unit.
Fig 7
raised ridges
Fig 8
clip tabs
Fig 9
Textured
surface
Brush
Bristles
Fig 10
Use
Brush
Bristles &
steam to
loosen
stain