Heath Zenith Motion Sensor Light Control 9700LeD - Manual

Dated receipt required for warranty replacement.
Features
• Automatically comes on when motion is detected.
• Automatically turns light off.
• Photocell keeps the light off during daylight
hours.
• LED indicates motion was sensed (day or night).
requirements
• The light control requires 120 volts AC.
• If you want to use Manual Override mode, the
control must be wired through a switch.
nOtiCe: Not to be used on light dimmer or timer-
controlled circuits.
• some electrical codes require installation by a
qualified electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in
wet locations.
• This light fixture has been tested/certified using
Lights of America LED Lamp Model Numbers
2003LEDP38-65K, 2002LEDR30-65K, and
2002LEDP30-65K.
unpaCking
Be sure to remove all contents from packaging and
verify all items are present before assembling this light
fixture. This package includes the following items:
• Security Light
• Two LED PAR38 lamps
(Lights of America Model: 2003LEDP38-65K)
• Two decorative lamp shells
• Mounting Strap
• Plastic Hanger
• Rubber Plug
• Mounting hardware
• Wire nuts
• Owner’s Manual
© 2008 598-1360-00
motion sensor
Light Control
model: 9700LeD series
instaLLatiOn
For easy installation, select an existing light with a
wall switch for replacement.
For best performance, mount the fixture about 8 ft.
(2.4 m) above the ground.
nOte: If fixture is mounted
higher than 8 ft. (2.4 m), aiming the sensor down will
reduce coverage distance.
For eave mount only:
1. Swing the sensor head towards the clamp screw
joint.
For under eave installation, the sensor head must
be rotated as shown in the next two steps for proper
operation and to avoid the risk of electrical shock.
Controls
Controls
Controls
eave mount
Wall mount
Clamp Screw
2. Then rotate the sensor head clockwise 180° so
the controls face down.
If the sensor pops out of the ball joint, loosen the
clamp screw and push the sensor back into the ball
joint. Tighten the clamp screw when done.