Harley-Davidson 74230 - Manual (Page 8)

3
• Insert a 25 amp fuse into the battery.
Note: The top of the fuse will not be flush with the top of the
battery when properly installed.
• Plug the charger connector into the battery connector.
• Plug the charger into a standard 120 volt wall outlet.
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is “ON”.
• Before first time use, charge the battery for at least
18 hours. Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each use
of your vehicle. Do not charge the battery longer than
30 hours.
• Once the battery is charged, disconnect the charger
connector from the battery connector. Unplug the charger
from the wall outlet. The battery is now charged and is
ready to be installed in your vehicle. Please see "Battery
Installation" on page 19 for detailed battery installation
instructions.
2
1
Battery
Connector
Charger
Connector
Battery
Clamp
25 Amp Fuse
Charger
Battery Charging
8
IMPORTANT! The battery must be removed from the vehi-
cle back fender for the initial charge in order to complete
assembly. After assembly is complete, you do not need to
remove the battery from your vehicle to recharge it.
• Using a Phillips screwdriver, loosen and remove the
screw in the battery clamp. Remove the battery clamp
from the vehicle body.
• Remove the Power Wheels ® 6 Volt (4.0 Amp/Hr.) battery
from the battery compartment.