Heath Zenith Wireless Outdoor Power Control 6022 - Manual (Page 2)

Regulatory Information
This device complies with Part 15 of the FCC Rules and RSS-
210 of Industry Canada. Operation is subject to the following
two conditions: (1) this device may not cause harmful interfer-
ence, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The user is cautioned that changes or modifi cations not expressly
approved by the party responsible for regulatory compliance
could void the user’s authority to operate the equipment.
WARNING: This product contains chemicals known to the
State of California to cause cancer or birth defects, or other
reproductive harm.
Troubleshooting Guide
SYMPTOM POSSIBLE CAUSE SOLUTION
Device does not come on. 1. Circuit breaker or fuse is turned off.
2. Switch on device is turned off.
3. Device is defective.
4. Signals from transmitter are being
blocked, or transmitter is out of
range.
5. Weak battery in the transmitter.
6. Dip switches on remote and outdoor
module do not match.
7. Remote set to automatic (Dusk to
Dawn) and surrounding light level is
too bright.
1. Switch circuit breaker or fuse on.
2. Switch device on.
3. Try remote using different device.
4. Check for metal objects that could
block the signal, or reposition the
transmitter.
5. Replace battery.
6. Verify dip switches on remote and
outdoor module match.
7.
Device does not turn off. 1. Same as 4 & 5 above.
2. Remote set to automatic (Dusk to
Dawn) and surrounding light level is
too dark.
Device comes on randomly. 1. Short term power line failure.
2. Another transmitter on the same
channel.
1. Wait for power to return and check
again.
2. Change channels on transmitter and
receiver.
Specifi cations
Range ................................................. Up to 100 feet (30.5 m)
Maximum Load ............................................ 13 amps resistive
960 Watts incandescent
960 Watts fl uorescent
1/3 H.P. motor
Rated Voltage .................................................120 VAC, 60 Hz
Battery ............................................12-volt alkaline (A23 type)
HeathCo LLC reserves the right to discontinue products and to
change specifi cations at any time without incurring any obligation
to incorporate new features in products previously sold.
Convenience Clip
The remote control is equipped with a removable clip for added
convenience. The clip may be removed to allow the remote to
lie fl at on table tops or other horizontal surfaces.
To remove clip. Insert a small fl at-head screw driver into slot
on back of remote. Gently push portion of clip inside of remote
with screwdriver while pulling clip out of remote from top (see
Figure 3).
Figure 3
Clip
Screwdriver