Heath Zenith HD-9250 - Manual (Page 8)

-8- 598-1187-02
Finish Mounting
❒ Align the JourneyMan ® cover plate, gasket,
and the mounting bracket hole. Secure with
M5 x 0.8 x 40 mm mounting screw supplied.
❒ Push the rubber plug firmly into place.
❒ If not installed on a weatherproof box, caulk
between the cover plate and mounting sur-
face with silicone weather sealant.
❒ Adjust the lamp holders by loosening the
thumb screws but do not rotate the lamp hold-
ers more than 180° from the factory setting.
When screwing in the floodlamps, do not
overtighten.
To avoid water damage and
electrical shock, keep lamp
holders aimed below horizontal.
Specifications
Range . . . . . . . . . . . . . 70 feet (21.0 m); 100
feet (30.5 m) with Range
Boost. Varies with sur-
rounding temperature.
Sensing Angle . . . . . . . Up to 270° (Adjustable)
Fixture Load . . . . . . . . Up to 300 Watts Maximum
Tungsten Incandescent
[Up to 150 Watts maxi-
mum each lamp holder.]
Sensor Load Capacity . Up to 1000 Watts (8.3
amps), Maximum Tung-
sten Incandescent
Power Requirements . . 120 VAC, 60 Hz
Operating Modes . . . . . TEST, AUTO, and MAN-
UAL OVERRIDE
Time Delay . . . . . . . . . 1, 5, 20 minutes
HeathCo LLC reserves the right to discontinue
products and to change specifications at any time
without incurring any obligation to incorporate
new features in products previously sold.
Rubber Plug